Through-bolt anchor S-KAK plus hot-dip galvanized

S-KAK+ – Hot-dip galvanized, European type-approved, ETA 16/0934 Option 1 – for cracked and non-cracked concrete.
Hot-dip galvanized for indoor and outdoor installations.
S-KA through-bolt anchor is a torque-controlled anchor for use in cracked and non-cracked concrete as well as natural stone.

S-KA+ easily passes through the material during through-installation and is easier to tap into the concrete thanks to its improved cone.
Two setting depths for sizes 8 mm, 10 mm & 12 mm, with the specified tfix measurement and dimension indicated on the anchor body.
Marking on the head shows which length and dimension have been installed, making inspection after installation easier.

Always follow the installation instructions for best results:
1) Drill a hole according to the table in the installation data below
2) Clean the hole with a brush and blow pump
3) Tap in the anchor
4) Tighten the anchor with the recommended torque using a torque wrench

I) Permissible loads in kN for concrete C20/25.

Shear load values apply to a single anchor without the influence of concrete edge.